Quicktouch (Qt4) Wireless Remote - Pentair EasyTouch PNP 5 Owner's Manual

Programming EasyTouch: Remote Controls

QuickTouch (QT4) Wireless Remote

The QuickTouch QT4 wireless remote controller provides switching of up to four circuits. For example, you
can use the QT4 wireless remote to activate the spa circulation, and for operating three auxiliary pieces of
equipment (such as heat enabled, lights, jet pump, heat boost, air blower, waterfall, etc.).
Each of the four functions on the QT4 wireless controller has an on and an off button. To switch a circuit on
or off, press and hold the appropriate button for at least a full second.
The QT4 buttons can be assigned to any available circuit. However, the QT4 has the following preset circuits
assigned to the four buttons:
• Spa button activates the spa circuit.
A button activates Auxiliary 1 circuit.
•
B button activates Auxiliary 2 circuit.
•
C button activates Auxiliary 3 circuit.
•
Getting There
MENU SETTINGS QUICKTOUCH ASSIGN QT4
To assign circuits to the QuickTouch wireless controller buttons:
Assign QT4

Circuit: 1/4
[SPA ]

Up/Down buttons: Select a circuit to assign to one of the QuickTouch wireless
remote buttons. You can set up to four circuits (1/4, 2/4, 3/4, 4/4).
Right button: Move to the circuit setting.
Up/Down buttons: To configure the first button (1/4) on the QuickTouch wireless
remote. Use these buttons to scroll through the circuit names and find the circuit
that you would like to assign to the first button. The generic circuits are: NONE,
SPA, POOL, AUX 1-7 (EasyTouch PNP 10), AUX 1-3 (EasyTouch PNP 5), FEATURE
1-8, AUX EXTRA (or SOLAR if selected in "Heat" menu), HEAT BOOST and HEAT
ENABLED. Selecting "None" does not assign a circuit.
Note: The "Heat Boost" feature will switch on the heater for seven minutes to
increase the spa water temperature. Each time the spa Heat Boost button is
pressed, the temperature will increase about 1°C. The temperature will not go
beyond the 40°C limit.
Right button: Assign the next circuit (2/4).
Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4),
then repeat the procedure for the other three buttons.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again
to return to the main screen.
Page 44