10 Button Pump Cntrl - Pentair EasyTouch PNP 5 Owner's Manual

To assign an iS10 and SpaCommand spa-side remote buttons:
IS4

10 BUTN SPA SD
10B Pump Cntrl
Quick Touch

Assign 10 BtnSS

Row : Top
Circuit : 1/5
[SPA ]


10 Button Pump Cntrl

From this menu setting you can specify the IntelliFlo VS, VF and VSF pump speed (RPM, GPM) in step
increments, for the assigned iS4, iS10 or SpaCommand button using the "Pump Incrs" or "Pump Decrs"
circuit. For example, the "Pump Incrs" and "Pump Decrs" circuit can be assigned to any two iS10 buttons.
Each press of the assigned "increase" button will increase the pump speed in specific speed increments,
as specified in the "iSx Pump Cntrl" menu setting. Speed increments are set from 10 to 250 RPM or 1 to 10
GPM.
Before setting the pump step speed, be sure to specify the IntelliFlo pump number and type in the IntelliFlo
menu ("Pump #1, Pump #2," Pump Type), see page 34.
Getting There
MENU  SETTINGS  10B PUMP CNTRL
To set a pump step speed:
IS4

10 BUTN SPA SD
10B Pump Cntrl
Quick Touch

Spa Side Pump#1
IFlo Control
Step RPM: 060
Size
Spa Side Pump#2
IFlo Control
Step RPM: 060
Size GPM: 010
Programming EasyTouch: Remote Controls
Up/Down buttons: Select the "Top" or Bottom" row to assign circuits to.
Right buttons: Select a circuit to one of the iS10 buttons. Five top row buttons can
be assigned circuits (1/5, 2/5, 3/5, 4/5 and 5/5). See "iS10/SpaCommand button
assignments" below for details.
Right button: Move to the circuit setting.
Up/Down buttons: To configure the first button on the iS10 Spa-Side Remote,
scroll through the circuit names and find the circuit that you would like to assign
to the first button on the iS4. The generic circuits are: NONE, SPA, POOL, AUX 1-7
(EasyTouch PNP 10), AUX 1-3 (EasyTouch PNP 5), FEATURE 1-8, AUX EXTRA (or
SOLAR if selected in "Heat" menu), HEAT BOOST and HEAT ENABLED. Selecting
"None" does not assign a circuit.
Note: The "Heat Boost" feature will switch on the heater for seven minutes to
increase the spa water temperature. Each time the spa Heat Boost button is
pressed, the temperature will increase about 1
beyond the 40° C limit.
Right button: Assign the next circuit (2/5).
Up/Down buttons: Select the first digit for the circuit number (1/5, 2/5, 3/5, 4/5)
and repeat the procedure for the other three buttons.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button twice to return to the main screen.
Up/Down buttons: Select the "Pump Number" as specified in the IntelliFlo menu
(see page 32).
Right buttons: Select the pump "Step" speed (RPM/GPM).
Up/Down buttons: Adjust the "Step" pump speed. Settings are:
- IntelliFlo VS: 10 to 250 RPM
- IntelliFlo VF: 1 to 10 GPM.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button twice to return to the main screen.
°
Page 43
C. The temperature will not go