Intellichlor; Salt Chlorinator Connection (Other Than Intellichlor) - Pentair EasyTouch PNP 5 Owner's Manual

IntelliChlor

While the EasyTouch system is in normal operating mode ("Pool," "Spa" mode or "Spa Fill (Spillway)," it will
control the IntelliChlor chlorine output level. The amount of chlorine introduced into the pool is determined
by the amount of salt in the water, water temperature, and the amount of time the pool pump is running
in "Pool" mode. Note: While in "Freeze Protection" mode, IntelliChlor will not operate or produce chlorine
during the time that the filter pump is operating. For more information, refer to the IntelliChlor Electronic
Chlorine Generator User's Guide.
Getting There
MENU  SETTINGS  INTELLICHLOR
To setup the IntelliChlor:
IntelliChlor 1/2

Enable: No
Level: 50%

IntelliChlor 2/2

Super Chlr: Off
Run Hours: 24


Salt Chlorinator Connection (Other than IntelliChlor)

1. Connect the supply cord to the salt chlorinator's power pack to the EasyTouch outlet marked "Filter
Pump".
2. If using a single speed pump, connect the pump to the outlet on the salt chlorinator's power pack
marked "Pump". If using an IntelliFlo pump, the pump should be on 15A permanent power and con-
trolled via the comm cable.
3. Set the salt chlorinator to "Manual" or "Override" to disable the power pack's timer.
Advanced Settings: Salt Chlorinator
Right button: Enable/Disable IntelliChlor. (To select SuperChlor, run hours, press
the Up/Down button - 2/2).
Up/Down buttons: Select Yes or No to enable or disable IntelliChlor.
Right button: POOL Mode "50%" setting.
Up/Down buttons: Set the chlorination output level for the pool water from 0 to
100%. EasyTouch will determine the chlorinator output level when the system is
operating in "Spa" or "Pool" mode. The amount of chlorine introduced into the
pool/sap is determined by the amount of salt in the water, water temperature,
and the amount of time the pool/spa operates in these modes mode.
Right button: SPA Mode "0%" setting.
Up/Down buttons: Set the chlorination output level for the spa water from
0 to 20%. To prevent over chlorination of the spa, the EasyTouch system will
automatically drop the chlorine output levels to 1/20th of the current pool output
when the spa is switched on. For example, if the pool output level is set to 60%,
when the spa is switched on, the chlorination level is reduced to 3%.
Right button: Move to the next set of settings (2/2).
Up/Down buttons: Select 2/2.
Right button: Move the Super Chlorination settings.
Up/Down buttons: Set Super Chlorination On or Off. See note below about Super
Chlorination.
Right button: Move to "Run Hours" setting.
Up/Down buttons: Set the number of hours to run Super Chlorination. 24 hours is
the default setting. Run hours can be set from 0 to 72 hours.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again
to return to the main screen.
Page 51