Table of Contents
Advertisement
IntelliFlo Menu(Continued)
Assigning an IntelliFlo Pump Address
When using multiple IntelliFlo pumps with EasyTouch you need to assign an address to each pump. The
address can be set to #1 or #2. The address set at the pump must match the IntelliFlo pump number
selected in the EasyTouch IntelliFlo PUMP # > PUMP TYPE menus. When only using one IntelliFlo pump
there is no need to follow this step as the pump is default set to address #1.
To assign an IntelliFlo pump address (Set On the IntelliFlo Pump):
1. Press the Start/Stop button to stop the pump. Be sure that the green power LED is on and the
pump is stopped.
2. Press the Menu button.
3. Press the Up and Down arrow buttons to scroll through the menu items. Press the Select button
to access the "Pool Data" menu (IntelliFlo VF) or "Settings" menu (IntelliFlo VS).
4. Press the Select button to access the "Pump Address" setting.
5. Press the Select button to change the current pump address.
6. To enter the new address number, press the Left and Right arrows to select which digit to modify,
then use the Up and Down arrows to change the selected digit.
7. When you are done assigning the pump address number, press the Enter button to save the
changes. To cancel any changes, press the Escape button to exit edit mode without saving.
Valves Menu
This feature lets you assign a circuit to Valve A or B. The EasyTouch system can drive two auxiliary valve
actuators (A and B) for applications such as solar heating and water features. By assigning AUX circuits to
control valve actuators, you can conserve auxiliary circuits for high voltage relays for controlling pumps and
lights.
Resides on the EasyTouch motherboard. If solar heating is setup and is not configured as a heat
Valve A:
pump, then Valve A is dedicated for controlling the solar heating valve actuator. Solar is enabled in the
"Solar" menu. The Valve A selection will display "USED SOLAR."
Resides on the EasyTouch motherboard. Can be configured to be controlled by any circuit.
Valve B:
Getting There
MENU
SETTINGS
VALVES
To assign a circuit to Valve A and Valve B:
Set Valves
A: [CLEANER
]
B: [FOUNTAIN
]
Set Valves
A: [USED SOLAR]
B: [FEATURE 1 ]
Programming EasyTouch: IntelliFlo
SETUP VALVES
Up/Down buttons: Select a circuit to assign to VALVE A. The generic circuit
names are: The generic circuits names are: NONE, SPA, POOL, AUX 1-7
(EasyTouch PNP 10), AUX 1-3 (EasyTouch PNP 5), FEATURE 1-8, AUX EXTRA (or
SOLAR) and HEATER. USED SOLAR is displayed when SOLAR is enabled from
the Solar menu. AUX EXTRA is displayed only available if the Solar output (J17)
plug on the EasyTouch motherboard is not being used for solar equipment. Use
the Solar button to switch the extra circuit on and off. Selecting NONE does not
assign a circuit.
Right button: Move to Valve B setting.
Up/Down buttons: Select a circuit to assign to Valve B. See above for the generic
circuits names.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again
to return to the main screen.
Page 37
Advertisement
Table of Contents
