Pentair EasyTouch PNP 5 Owner's Manual page 46

Advanced Settings: Lights
Setting up lights (Continued)
Modes (Color Set)
The "Color Set" feature allows any combination of up to eight (EasyTouch PNP 10) or four (EasyTouch PNP
5) IntelliBrite lights, and SAm, SAL and or Fiberworks lighting to be preset to specific colours. Fixed light
colours are selected and activated from the Colors screen.
IntelliBrite Light: If the light was not previously on, after selecting the fixed coloured light, no illumination
will occur for approximately six (6) seconds followed by the selection. If the light was previously on, after
selecting the coloured light, the previously selected colour will momentarily illuminate, no illumination will
occur for approximately six (6) seconds followed by the selection.
Colors
Choose any one of the five fixed colours to create a spectacular underwater lighting effect. The fixed colours
are: Blue, Green, Red, White and Magenta. You can switch each fixed coloured light on or off from the
Colors screen.
IntelliBrite Light: If the light was not previously on, after selecting a fixed coloured light, no illumination
will occur for up to ten (10) seconds (depending on the selection), then a white light will momentarily
illuminate, followed by the colour selection. If the light was previously on, selecting the a colour button will
momentarily illuminate the previously selected colour before changing to the selected colour.
To select a fixed color press:
Blue

Green
Red
White

Green

Red
White
Magenta

Magenta
Hold/Recall
Select Hold and Recall from the "Modes" or "Color" screen to capture and save a unique colour effect and
recall it at a later time. For example, while a light show (Romance Mode) is active, select "Hold" to save the
exact colours that are being displayed, then later, to recall the exact colour effect, select "Recall."
Note: After selecting Hold or Recall, no illumination will occur for up to 10 seconds, then a white light will
momentarily illuminate, followed by the saved colour.
All On / All Off (Lights Menu)
Select All On or All Off from the Lights screen to manually switch all lights on or off, including any
MagicStream laminar circuits. Press the control panel auxiliary button (AuxX) assigned to a light circuit will
also switch a light on or off.
Sync
Select Sync from the "Lights" screen to synchronize colours for all IntelliBrite, SAm, SAL and FIBERworks
colour changing lights.
Menu > Lights > Modes > Colors
Up/Down buttons: Choose a colour for the light.
Right button: Switch the selected coloured light ON. To switch the light
off, go to the main Lights menu and select All Off, or press the AUX button
assigned to the light. The AUX button will also switch the light on. Press
the Menu button three times to return main menu.
WARNING - IntelliBrite Lights: During the off/on switching process,
before the selected colour is displayed, no illumination will occur. This
operating mode is normal during the switching process. During this
period the pool and spa will be dark and precautions should be taken to
avoid unforeseen accidents. Failure to observe this warning may result in
serious injury or death to pool and spa users.
Page 46
: