Resetting The Controller; Resetting The Eeprom; Resetting The Hardware - Pentair SIATA V132-SFE-EV-VIRIDION Installer Manual

Note
The statistical data are reset to 0 and the message CLS flashes on the display for a few
seconds.
6.6.

Resetting the controller

6.6.1. Resetting the EEPROM

To reset the EEPROM to the default values, the controller must be in the service condition (no
regeneration cycle running and clock displayed).
A Open the Statistics menu.
→ See 6.5. Statistics, page 65.
B Press and release
C Press and release
D Press and release
E Press and hold
→ The display shows rSt for a few seconds. The EEPROM has been reset.
Note
This procedure does not reset the statistical data.

6.6.2. Resetting the hardware

The SFE-EV-VIRIDION controller is fitted with a hardware reset button located on the board itself
close to the display and not directly accessible by the user.
After a hardware reset, the time on the display flashes until any button is pressed.
Ref. MKT-IM-009 / C - 08.06.2018
Installer Manual Siata V132-SFE-EV-VIRIDION - Programming
.
.
.
for 5 seconds.
Hardware reset
button
67 / 110