Table of Contents
Advertisement
Programming EasyTouch: Circuit Functions
Circuit Functions
Assigning Circuit Functions
Getting There
MENU
SETTINGS
CIRCUIT FUNC.
From the "Circuit Functions" menu you can assign special logic to the cleaner pump, spa spillway, lights
and MagicStream laminar circuits. For example, when setting up an automatic pool cleaner pump you
would assign the circuit function "MASTER CLEANER." With this "Cleaner" logic the cleaner pump
would force the filter pump on, and the cleaner pump would start after a delay of five minutes. The
cleaner pump would automatically shut off whenever the spa and/or solar is switched on.
Circuit/Func.:
[SPA
]
[Master Spa
]
Freeze: No
Circuit/Func.:
[AUX 1
]
[LIGHT
]
Freeze: No
Freeze Protection
Freeze protection switches on a circuit if the outside air temperature sensor detects the temperature is
getting close to freezing (below 2°C). The system will switch on all circuits that have been assigned freeze
protection, and runs the circuits for 15 minutes to stop the pipes from freezing. This is especially important
if the pool is in a cold climate where the temperature is cold enough to freeze water in the pipes and
equipment. IN MOST PARTS OF AUSTRALIA & NEW ZEALAND FREEZE PROTECTION IS UNNECESSARY. If
freeze protection is set to both the spa and pool circuits, the filter pump switches on and the pool and spa
valves alternate every 15 minutes to keep the water moving in both the pool and spa. This process continues
until the freeze condition is over. Freeze protection is ON by default for the Pool and Spa circuits, unless you
are located in an alpine region in Australia or Southern New Zealand, you should deactivate it.
Getting There
MENU
SETTINGS
CIRCUIT FUNC.
To deactivate/activate freeze protection:
Circuit/Func.:
[SPA
]
[Master Spa
]
Freeze: Yes
Circuit/Func.:
[SPA
]
[Master Spa
]
Freeze: No
Up/Down buttons: Choose the circuit name (displayed on the second line). The
generic circuits names are: SPA [MASTER SPA], POOL [MASTER POOL], AUX 1-7,
FEATURE 1-8 and AUX EXTRA* or SOLAR (if enabled in the Solar menu).
Right button: Move to the "Circuit Function" setting to select the circuit function
for the select circuit name displayed on the line above.
Up/Down buttons: Select the circuit function. This is the circuit that you wish to
assign the function logic to. For a complete list of preset circuit functions, see
table below.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again
to return to the main screen.
*AUX EXTRA is only available if the Solar output (J17) plug on the EasyTouch
motherboard is not being used for solar equipment. Use the Solar button to
switch the "extra" auxiliary circuit on and off.
Up/Down buttons: Choose the circuit name (displayed on the second line).
Right button: Move to the "Freeze" setting to select the circuit for the freeze
protection.
Up/Down buttons: Select "No" to deactivate circuit freeze protection. Select "Yes"
to activate circuit freeze protection. Press the Menu button to save the settings
and to return to the Settings menu options. Press the button again to return to the
main menu options or press again to return to the main screen.
Page 30
Advertisement
Table of Contents
