Preparing The Easytouch Load Centre Enclosure - Pentair EasyTouch PNP 5 Owner's Manual

Preparing the EasyTouch Load Centre Enclosure

Before mounting the EasyTouch load centre, first remove the front door and the high voltage panel
to access the electrical connections and low voltage raceway.
To remove the EasyTouch load centre front door and high voltage panel
1. Unpack the load centre from the shipping box.
2. Unlatch the front door spring latches, and open the front door.
3. Remove the front door from the hinges.
4. Remove the screws securing the high voltage cover-panel. Remove the cover-panel from the
enclosure.
5. Proceed with:
• Mounting the EasyTouch Load Centre, page 10
• Installing Conduit and Wire to the EasyTouch Load Centre, page 11
• EasyTouch Motherboard Connections, page 14
• Accessing the EasyTouch motherboard, page 15
6. After electrical connections have be completed, reinstall the enclosure door on its hinges and
install the door release screw. Reinstall the high voltage panel and secure with the retaining
screws.
Enclosure door
EasyTouch Load Center (front view)
Page 9
Electrical Installation
Retaining screw
High voltage
panel
Door Hinges