Table of Contents
Advertisement
Programming EasyTouch: Heat
Heat Menu
Use the heat menu settings to specify the set point temperature and select the heat source for the pool and
spa water. The water will begin to heat whenever the water temperature is below the set-point. There is a
different set point for "Pool" and "Spa" modes, you can switch between modes by pressing the Valves (V)
button (on the Outdoor Control Panel) or the "Pool" or "Spa" button on the Indoor Control Panel. The spa
will also begin to heat when switched on by the optional iS4/SpaCommand Spa-Side remote, or EasyTouch
wireless remote. The EasyTouch system allows for solar and conventional heaters. The EasyTouch will use
the heating source that is selected. The heat source selections are:
- No heating even though pump and other circuits may be operating.
•
OFF
- Gas heater only. Use the Heater button to automatically switch the heater on which
•
HEATER
controls the output between a "forced off" state and a normal, automatic thermostatic control
operating state. The heater will continue heating the water until the heater's current highest
set point temperature triggers the heater sensor (40° C). Note that in Service mode, the Heater
button on the control panel does not activate the pump. Do not activate the heater without
running the pump. The heater will not run if water flow is not detected.
•
- Solar heating system to be the only heat source. In order to display solar options
SOLAR ONLY
on the main screen, you must first enable solar in the "Solar" menu (see following section).
•
SOLAR PREF. (Solar Preferred)
solar heating only when it is most effective.
To set the pool temperature and select the heat source:
Getting There
MENU
HEAT
POOL Temp/Src
SPA Temp/Src
POOL
Temp: 27°C
Heat: Off
To set the spa temperature and select the heat source:
POOL Temp/Src
SPA Temp/Src
SPA
Temp: 35°C
Heat: Off
- Solar and gas heating systems are installed, and you want to use
Right button: Select pool temperature and heater options.
Up/Down button: Set the pool temperature from 4°C - 40°C.
Right or Left button: Move to Heater option.
Up/Down: Set Heater option: Off, Heater, Solar, or Solar Preferred.
Press the Menu button to save the settings and to return to the previous menu or
press the button again to return to the main screen.
Right button: Select spa temperature and heater options.
Up/Down button: Set the spa temperature from 4°C - 40°C).
Right or Left button: Move to Heater option.
Up/Down: Set Heater option: Off, Heater, Solar, or Solar Preferred.
Press the Menu button to save the settings and to return to the Heat menu or
press the button again to return to the main screen.
Page 32
Advertisement
Table of Contents
