Connection Of A Disinfection System To The Probe Unit; Connection Of An Intellichlor Salt Chlorinator; Connection Of A Liquid Chlorine Pump; Connection To A Conventional Salt Chlorinator - Pentair IntelliPool User Manual

Connection of a disinfection system to the Probe Unit

Connection of an IntelliChlor salt chlorinator

1 - Connect the 230 V.
2 - Connect the IntelliFlo ref 350122/15-m cable supplied with IntelliPool
3 - Connect the green cable to Datas+ and connect the yellow cable to Datas-.
4 - Connect the green strand on terminal 2 and the yellow strand on terminal 3 of the IntelliChlor
BUS BUS
3

Connection of a liquid chlorine pump

1 - Connect the chlorine pump and the pH corrector level sensor as described below. Select "other" in the Settings/Install/Other menu, see p18.
NEUTRAL (N)
EARTH
PHASE (L)
The chlorine injection must be placed after filtration, after the heat pump
and after the probes.

Connection to a conventional salt chlorinator

1 - Connect a conventional electrolyser as described below.
12
pH CL
NEUTRAL (N)
PHASE (L)
pH
N L
AUX1 CL
230 V ~
®
.
5-230 V~
OR
BUS
Chlorine
pH
N L
AUX1 CL
230 V ~
®
Power Centre.
Communication
for IntelliChlor ®
1
2
pH CL
BUS BUS
Chlorine level sensor is normally open.
(Closed switch = empty tank)
5-230 V~
OR
BUS
PHASE (L)
EARTH
NEUTRAL (N)
centre
4
1
2
3
4