Table of Contents
Advertisement
Setting up lights (Continued)
Config
From the "Config" screen you can setup the IntelliBrite light position, and specify the colour of each pool
and spa light. Any combination of up to eight (EasyTouch PNP 10) or four (EasyTouch PNP 5) IntelliBrite
lights, SAM, SAL and or Fiberworks lights can be preset for specific colours and position when using the
"Color Swim" and "Color Set" feature. Fixed light colour are selected and activated from the Colors screen.
Note: The "Config" menu settings do not apply to the MagicStream laminars.
To select configure a light position and color: Menu > Lights > Config:
1- [POOL
]
2- [SPA
]
3- [BACK YARD ]
4- [AUX 4
]
5- [NONE
]
6- [NONE
]
7- [NONE
]
8- [NONE
]
[ AUX 4
]
[ LAVENDER
]
[ 1ST POSITION ]
[ DELAY 5 SECS ]
Smart Start (SS: Yes/No) - Select Smart Start in the Schedules menu (see page 27). The Smart Start
feature automatically starts changing colours when the lights are programmed to switch on. Smart
Start is used when Color Swim and IntelliBrite show modes are being used.
Up/Down buttons: Choose the light circuit (1-8) to configure. Select an available
auxiliary circuit (NONE). For more about assigning an auxiliary circuit to a light,
see "Circuit Functions (page 30) and "Circuit Names" (page 28). EasyTouch PNP
10 supports up to eight (8) auxiliary circuits, EasyTouch PNP 5 supports up to
four (4) auxiliary circuits.
Right button: Select the light to setup.
Up/Down buttons: Select the light circuit.
Right button: Move to the light colour selection.
Up/Down buttons: Select the light colour (Blue, Cyan, Green, Lt. Green,
White, Lt. Magenta, Magenta, Lavender).
Right button: Move to the light position selection.
Up/Down buttons: Select the light position. A light can be assigned to any
position from 1 through 12. To ensure that the "Color Swim" and "Color Set"
lighting feature colour effects are correct, set the position of the light according
to where it's located in the pool or spa. Position 1 will lead all the other lights
in the colour changing sequence. Position 2 follows Position 1 and so on. There
are 12 position to choose from. More than one light may be assigned to the
same position number so that their colours may be synchronized. For example,
to make the colours swim right to left, make your right most light Position 1.
You may need to go back to and scroll through your lights to find the right most
light, and set it as Position 1.
Right button: Move to the light delay selection. The Delay time between two or
more lights can be set from 0 to 60 seconds. Use a higher delay time for lights
spread further apart. Try five seconds for all lights and observe the effect. Use
different time settings to achieve unique lighting moods and effects.
Press the Menu button to setup other lights or press Menu button four times to
return main screen.
Page 47
Advanced Settings: Lights
Advertisement
Table of Contents
