Settings Menu: 2-Speed Pump - Pentair EasyTouch PNP 5 Owner's Manual

Settings Menu: 2-Speed Pump

Equipment circuits selected in this menu will automatically switch a two-speed filter pump to high speed
when these circuits are on. If a two-speed pump is assigned to solar, a cleaner or a pump, when activated
the pump will automatically run for five minutes in high speed then switch to low speed. For example,
when on, the filter pump will switch to high speed whenever the JETS or CLEANER is on. There must be a
two-speed relay installed in the EasyTouch Load Center in order for the "2-Speed Pump" menu settings to
function.
Getting There
MENU SETTINGS 2-SPEED PUMP
To configure a two-speed pump to a circuit:
2-Speed Pmp 1/4

Circuit:
[SPA HEATER ]

Up/Down buttons: Select a circuit that will switch the filter pump to high speed.
You can set up to four circuits to use a two-speed pump (1/4, 2/4, 3/4, 4/4).
Right button: Move to assign a circuit setting.
Up/Down buttons: Select the circuit to assign to a two-speed pump. The generic
circuits names are: NONE, SPA, POOL, AUX 1-7 (EasyTouch PNP 10), AUX 1-3
(EasyTouch PNP 5), FEATURE 1-8, SOLAR, HEATER, POOL HEATER, SPA HEATER
and FREEZE. AUX EXTRA is displayed only available if the Solar output (J17) plug
on the EasyTouch motherboard is not being used for solar equipment. Use the
Solar button to switch the extra circuit on and off (see page 5). Selecting NONE
does not assign a circuit. Note: You can use a Feature circuit to change a 2-Speed
pump to high speed.
Right button: Assign the next circuit (2/4).
Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4).
Right button: Move to circuit setting.
Up/Down buttons: Select the next circuit. When finished press the Menu button.
Press the Menu button to save the settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again
to return to the main screen.
Advanced Settings: 2-Speed Pump
Page 53