Mounting The Easytouch Load Centre - Pentair EasyTouch PNP 5 Owner's Manual

Electrical Installation

Mounting the EasyTouch Load Centre

The EasyTouch load centre can be mounted on a flat vertical surface, such as a wall
or post.
To mount the EasyTouch load centre:
1. Position the EasyTouch load centre against the vertical flat surface. If wall an-
chors are being used, support the EasyTouch load centre enclosure in position
(horizontally level and square) against the surface and mark the bracket hole
pattern on the wall.
2. Secure the enclosure with three (3) screws in the top and lower mounting bracket
holes. If using wall anchors, drill and set the anchors and secure the enclosure
with screws.
Top mounting bracket screw holes
Lower mounting bracket screw holes
EasyTouch Load Center (front view)
(front door and high voltage panel removed)
Page 10