Unloading The Etek5 - Eclipse ETEK 5 User Manual

USING THE ETEK5

UNLOADING THE ETEK5

Securely attach a barrel blocking device such as the Eclipse Barrel Sock
(supplied with the ETEK5) to the marker as shown in
Turn off the ETEK5 - see pages 8 and 9 for information on turning off the ETEK5
(see figure
via the navigation console
With the ETEK5 barrel pointing away from you. De-gas the marker by turning
OOPS knob clockwise until the OOPS begins to vent air. Only when the OOPS
has fully degassed the ETEK5 marker should you unscrew the air system from
the OOPS (see figure 16C).
Open the clamping lever on the feed neck and slacken off the top feed screw
if necessary on the feed neck. Carefully pull the loader out of the feed neck
(see figure 16D).
Looking down the feed neck, check to see if there are any paintballs still in the
breech, if there are, turn the marker upside down while still keeping the barrel
facing away from any persons within firing range then tip out any paintballs within
the breech (see figure 16E).
Next remove the barrel blocking device, and unscrew the barrel
Remove any paintballs within the barrel.
The ETEK5 has now been unloaded and is ready for storage.
1 Instruction on using the Eclipse Barrel Sock can be found on the sock warning label.
WARNING!
Always keep the Eclipse ETEK5 pointed in a safe direction and ensure
all persons within range continue to wear face protection, until marker is
completely unloaded and safe.
22 ETEK5 MANUAL
1
figure 16A.
16B).
(see figure 16F).
WARNING
FIG 16A FIG 16B
FIG 16C FIG 16D
FIG 16F
FIG 16E