Eclipse ETEK 5 User Manual page 18

USING THE ETEK5
INSTALLING A PRESET AIR SYSTEM (CONTINUED)
High, mid and low pressure output preset air systems can be used with the
ETEK5, providing the ETEK5 is fitted with the SL4 inline regulator originally
supplied with the marker.
There are two retaining screws on the On/Off Purge System (OOPS) body
underside (see figure 12A). These are used to clamp the OOPS onto the frame.
It is advisable to make sure that these screws are tight using a 5/32" hex key
before attaching an air system.
The Eclipse ETEK5 comes complete with an Eclipse On/Off Purge System
(OOPS) which provides a direct connection for a preset air system. Before
screwing an air system into the OOPS ensure that the OOPS knob is fully
unscrewed (see figure 12B). In this position the OOPS is off and will not
pressurise the ETEK5 when an air system is screwed into the OOPS.
Lining the threads up correctly between the OOPS and the air system, screw the
air system into the OOPS until the air system is screwed all the way in and tight
on the OOPS. The air system MUST be screwed all the way in before turning on
(see figure 12C).
the OOPS
Now with the air system attached and the barrel pointing away from you, start
to slowly turn the OOPS knob counter-clockwise to turn the OOPS on and
pressurise the ETEK5. Keep turning the knob until it stops against the OOPS
body as shown in figure 12D.
You have now installed a preset air system onto your ETEK5.
18 ETEK5 MANUAL
FIG 12A FIG 12B
FIG 12C
FIG 12D