Table of Contents
Advertisement
10. DIAGNOSTICS
10.1 FIRMWARE VERSION
The firmware version is show on the display for 5
seconds each time it is switched on.
10.2 CHECKING THE MOVEMENT
Access basic programming and use function
Leaf2 (displayed if the automation is configured for 2
M1
leaves) and function
for Leaf1.
1. The function displays
+ +
and - - in dead man mode. One of
2. Use buttons
the expected commands must be given:
+ +
oP
to OPEN (
on the display)
cL
- -
to CLOSE (
on the display)
Otherwise, temporarily disconnect the power supply
and invert the phases (OP/CL) of the motor.
9 Status of the LEDs
LED
colour
meaning
OPEN A
red
Total motion command
OPEN B
red
Partial motion command
STOP
red
Stop command
5V
blue
Power supply 5 V
24V
blue
Accessories power supply 24 V
BUS
red
Bus 2easy devices
BUS MON green
Bus 2easy devices
USB
red
USB pen drive inserted (*)
RADIO1
red
Channel 2 Omnidec (*)
RADIO2
red
Channel 2 Omnidec (*)
(*) Additional LED status or meanings are shown in the section on the accessory to which it refers.
LED
colour
meaning
ERROR
red
Error/alarm signalling
E045S
M2
--
.
"
10.3 AUTOMATED SYSTEM STATUS
The display, other than in the programming menu,
provides information regarding the status of the
automation system:
8 Automated system status
for
00
CLOSED
01
OPEN
02
STATIONARY THEN OPENS
03
STATIONARY THEN CLOSES
04
IN PAUSE
05
OPENING
10.4 LEDS CHECK
9 bold indicates the condition of the LEDs with the
board powered, the gate at its halfway position and no
connected device active (=on ; =off).
active
active
not active
on
on
see § Bus 2easy devices
Installed
active
active
alarm in progress
24
06
CLOSING
07
FAILSAFE IN PROGRESS
08
CHECK Bus 2easy
09
PREFLASHING BEFORE OPEN-
ING
10
PREFLASHING BEFORE CLOS-
ING
not active
not active
active
off
off
not inserted
not active
not active
error in progress
not active
532373 - Rev.A
Advertisement
Table of Contents
