I Mportant Information; I Mportant Installation Instructions; R Adio And Television Reception - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

I mportant Information

0 B

I mportant Installation Instructions

2 8 B
WARNING - To reduce the risk of server injury or death, material damage and malfunction of the
product, the instructions contained in this manual must be strictly observed during installation,
adjustment, repairs, service, etc. Only Besam trained technicians should be allowed to carry out these
operations.

R adio and television reception

2 9 B
This equipment generates and uses radio frequency energy and if not installed and used properly in
strict accordance with the manufacturer's instructions, may cause interference to radio and television
reception. It has been designed to comply with the emission limits in accordance with EN 50081-1
(US market FCC Part 15), which are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Re-orient the receiving antenna.
•
Relocate the receiver with respect to the equipment.
•
Move the receiver away from the equipment.
•
Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions.
Note!
Besam follows a policy of advancements in development.
Instructions, design, specifications and illustrations, which are contained in this manual, are not
binding. Rights are reserved for changes without previous notice.
Note!
The glazing material in all unframed swing doors shall comply with the requirements in the
Performance Specifications and Methods of Test for Safety Glazing Material Used in Buildings,
ANSI Z97.1. Glazing materials for other pedestrian doors shall also comply with ANSI Z97.1,
except that single strength or heavier glass may be used for those portions of doors involving a
glazed area of less than 1sqf and having no dimension greater than 18".
Besam Entrance Solutions 1 1/31/2008