S Urface Mount Installation - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

S urface Mount Installation

5 6 B
1. Establish the installation height and the correct width of the header.
Dismantle the header from the cover (reference, section titled, "Part Identification &
2.
Options").
Mark and drill the fixing holes and the holes for the cable inlet in the header (see
3.
drawing for the arm system used, reference, section titled, "Surface Mount Installation").
Use the header as a template. Mark and drill for cable inlets and mounting holes into the
4.
jamb/header (non-pivot side preferable) for the correct operator model and arm system.
Install the header using appropriate screws, or if required, Riv-Nuts. Be sure the header
5.
is level left to right as well as front to back.
Note!
If installing on a door with swing clear hinges be sure to maintain a maximum distance of 3 ¾"
(94mm) from centerline of spindle to centerline of pivot.
6. Install the external cables through the cable inlet holes. The cables can enter the casing from the
hinge/pivot side or from the strike side, but it is always desirable to bring all wiring in at the
strike side because of the tight conditions between the operator and the end cap.
Install the short center panel to the header on the right or left side according to the
7.
handing of the door.
Install the long center panel.
8.
Install the operator.
9.
Secure the hinge/pivot side operator mount to the short center panel, then attach the
10.
support bracket and clamp plate to the header as shown in the illustration below.
Secure the motor side operator mount to the long center panel.
11.
Mount the shaft adapter on the drive shaft (see section titled, "Arm Systems (Surface
12.
Applied).
13. Mount the arm system and the door fitting (see section titled, "Mounting the Arm System").
Install and make electrical connections (see section titled, "Electrical Connections and
14.
Adjustments"), then install the cover.
Besam Entrance Solutions 26 1/31/2008