1. Signage - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

1 1. Signage

9 5 B
Besam Entrance Solutions
10.2.10 The opening at hinge side of swinging door shall be: a) Less
than ¼ in./6 mm wide with the door in any position, or b) At
least ¾ in./19 mm wide with the door in any position. A door
that does not comply with the above is acceptable if provided
with a finger guard.
Consistent with section 2.2.2 of ANSI Z535.4 the "signage and warnings"
guidelines of A156.10 are recognized, industry specific standards that predate
the adoption of Z535.4 and are not replaced by the standards set forth therein.
11.1 All Swinging, sliding and folding doors shall be equipped with
signage visible from both sides reading "AUTOMATIC
DOOR" with letters ½ in. high minimum. The sign described in
figures B-1, B-3, and B-5 shall be permitted to be used to satisfy
this requirement.
11.2.1 An arrow sign shall be visible from the approach side of a
swinging door mounted on the door at a height of 58"+ 5 in.
from the floor to the center line of the sign. The sign shall be a
minimum of 6 in. in diameter, having a green circle surrounding
a black arrow on a white background.
11.2.2 An International "DO NOT ENTER" sign shall be visible from
the side of doors that swings towards pedestrians attempting to
travel in the wrong direction mounted on the door at a height
58"+ 5 in. from the floor to the center line of the sign. The sign
shall be a minimum of 6 in. in diameter, having a red circle with
the wording, "DO NOT ENTER", in the red circle
48 1/31/2008