P Re-Installation Adjustments; C Am Adjustment; C Hanging The Hand Of The Operator - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

P re-installation Adjustments

1 4 B

C am Adjustment

4 6 B
The bottom cam and its two switches (Panic & Home Switch) are factory set at the home position.
1. The latch switch is factory set on the same cam to switch at 10-12 degrees from the closed
position. If more or less latch is needed bend the switch arm slightly away from the cam for
more latch, towards the cam fore less.
2. If pre-load is applied, or the centering of the arm has been adjusted, loosen the bolt in the
center of the cams with a 7/16" wrench and adjust the bottom cam so that the home and
panic switches are not being activated at the door home (closed) position. Re-secure bolt
when finished.
3. The top cam is factory set as either a right hand or left hand and switches at 80 degrees.
4. If the back check position needs adjustment, loosen the bolt in the center of the cams with a
7/16" wrench and rotate the top cam to the desired position. Re-secure bolt.

C hanging the Hand of the Operator

4 7 B
1. With the door and operator at the home position, loosen the top 7/16" bolt and turn the top
cam aligning the handing mark to the hand indicated on the bottom cam.
2. Re-secure 7/16" bolt and check for proper functionality.
(1) Back Check Switch
(2) Bottom Cam
Besam Entrance Solutions
(3) Break Out Switch
(4) Latch Switch
17
(5) Top Cam
(6) Home Switch
1/31/2008