Important Information - Besam SW200i Installation And Service Manual

Swing door operator (ohc)
Hide thumbs Also See for SW200i:
Table of Contents

Advertisement

2

Important information

Failure to observe the information in this manual may result in personal injury or
To reduce the risk of injury to persons - use this operator with single or double ped-
2.1
Intended use
The Besam SW200i is an automatic swing door operator developed to facilitate entrances to
buildings and within buildings through swing doors. The Besam SW200i is a universal electro-
mechanical operator that combines a Heavy Duty (HD) operator for large heavy doors with Low
Energy (LE) applications of swing doors. The operator is factory set to Low Energy (LE).
The Besam SW200i can be concealed or surface applied on either side of the door for pull or push
action, and is suitable for single doors, double doors and double egress doors fitted with swing
clear hinges, offset or center pivots.
The Besam SW200i ensures all-around safety. The operator can be combined with a full range of
sensor products providing swing door safety, but meets also the requirements for a low energy
operator without any sensors.
The operator is connected to the door leaf with a range of different arm systems.
The door is designed to offer continuous use, a high degree of safety and maximum lifetime.
For use see User manual 1007717.
2.2
Safety precautions
Do not climb on door parts.
Do not let children play with the door or the fixed controls.
Be sure to complete a risk assessment (PRA-0002) and the site acceptance test (PRA-0007) before
taking the door into operation.
To avoid bodily injury, material damage and malfunction of the product, the instructions contained
in this manual must be strictly observed during installation, adjustment, repairs and service etc.
Training is needed to carry out these tasks safely. Only ASSA ABLOY Entrance Systems US Inc.-trained
technicians should be allowed to carry out these operations.
2.3
Electronic equipment reception interference
The equipment complies with the European EMC directive (US market FCC Part 15), provided in-
stalled according to Installation and Service manual.
The equipment may generate and use radio frequency energy and if not installed and used properly,
it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements interference may occur.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by
1009937-EI-1.0
HAZARD WARNING!
damage to equipment.
estrian swinging or folding doors only.
Save these instructions for future reference.
Issue 2013-02-10
2 Important information
5

Advertisement

Table of Contents
loading

Table of Contents