0. Entrapment Protection - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

Table of Contents

Advertisement

1 0. Entrapment Protection

9 4 B
Besam Entrance Solutions
10.2 Swinging Doors
10.2.1 The opening time of a swing door to 80 degrees shall not be less
than 1.5 seconds
10.2.2 The force required to prevent a stopped power operated door in
the last 10 degrees of opening from moving in the direction of
opening shall not exceed 40 lbs. Measured 1 in. from the lock
edge of the door.
10.2.3 Back check shall occur at no less than 10 degrees of the full
open position.
10.2.4 Swing doors utilizing sensors or control mats shall remain open
a minimum of 1.5 seconds after loss of detection unless other-
wise specified in this standard.
10.2.5 A swing door shall be adjusted so that the closing times to latch
shall be the minimum values in the following table:
Inches (mm)
(D)
36 (914) & under
36 (914)
42 (1067)
42 (1067)
48 (2119)
48 (2119)
48 (2119)
10.2.6 Latch Check shall occur for swinging doors at no less than 10
degrees from closed position and the door shall not close
through the final 10 degrees in less than 1.5 seconds.
10.2.7 The force required to prevent a stopped power operated swing-
ing door from moving in the direction of closing shall not
exceed 30 lbs. Measured 1 in. from the lock edge of the door at
any point in the closing cycle.
10.2.8 In the event of a power failure, a swing door shall be capable of
being opened manually with no greater than 30 lbs. Applied 1 in.
from the edge of the lock stile to open.
10.2.9 Swinging doors provided with a break away device shall require
no more then 50 lbs. Applied 1 in. from the edge of the lock stile
to open. When the door(s) is opened in the breakout mode,
power-operating components excluding spring power shall not
operate the door.
Lbs. (kg)
Time
(W)
T (secs.)
to 100 (45)
2.0
to 140 (64)
2.3
to 110 (50)
2.3
to 150 (68)
2.7
to 120 (55)
2.8
to 160 (73)
3.2
to 220 (99)
4.0
47
1/31/2008

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents