L Ed Indications & Terminal Descriptions - Besam ASSA ABLOY Swingmaster 900 Service And Installation Manual

L ED Indications & Terminal Descriptions
8 8 B
HLD Hold
BKO Breakout
IMP Impulse
OPD Overhead
Presence
Detector
TB1: 1 IMP
Impulse
TB1: 2 OPD
Overhead
Presence
Detector or
Mat
TB1: 3 OVDC
Common
TB1: 4 BC1
Back Check
1
TB1: 5 BC2
Back Check
2
TB1: 6 LOT
Lock Out
Trigger
TB1: 7 HLD
Hold
Besam Entrance Solutions
Orange Illuminates when in hold.
Yellow Goes out when in breakout
Green Illuminates when a contact is made between IMP an 0VDC
Red Illuminates when a contact is made between OPD and 0VDC
Note: Only visible on master control if installed as a pair.
Input A closed contact to 0VDC will start an automatic opening cycle
Input A closed contact to 0VDC will prevent a closed door from opening
and keep an open door open. It will also keep a closing door from
reopening. Used for an overhead presence detector or a safety mat
input.
Common 0VDC = Common
Output An open contact until back check switch is activated by the top cam,
then 0VDC in the back check area. Used to inhibit a door mounted
(Switching
sensor on the swing side between 80 (or earlier) and 90 degrees to
Common)
avoid sensing of a barrier or wall.
Output 0VDC output until back check switch is activated by the top cam,
then open in the back check area. Used to inhibit a door mounted
(Switching
sensor on the swing side between 80 (or earlier) and 90 degrees to
Common)
avoid sensing of a barrier or wall.
Output Open contact when door is opening and during "TD" and 0VDC
when "TD" has expired. Used to inhibit the "OPD" while doors are
(Switching
closing.
Common)
Input A closed contact to 0VDC will stop an opening door, when contact
disappears the door will continue to open if the time delay hasn't
expired. If time delay has expired and there are no other signals the
door will return to the home position. Used for a door-mounted
sensor on the swing side of the door.
40 1/31/2008