Table of Contents
Advertisement
Component Identification
INFRARED LENS
WIDE IR US21-0640-07
NARROW IR US21-0640-08
(Not available as a spare part)
US02-0640-01
US21-0640-06
INTERFACE BOARD
Ultraview Replacement Sensor Kit
One assembled unit consisting of sensor, shroud, cover, wide lens, narrow lens,
mounting screws and quick disconnect harness.
Electrical Installation
Connect the Extension Harnesses to the Ultraview Interface Board at the control as follows:
1. Designate the sensors as P1 or P2.
Important: The side of the door "not intended for use" when door is in one-way mode will be
2. The longer extension harness has a gray jacket and will be connected to the sensor on the
plank side. The shorter extension harness has a black jacket and is connected to the header
access side. Based on Step 1, connect the appropriate extension harness to the appropriate
connector on the Ultraview Interface Board.
Ultraview US23-0640-09
© Copyright 2009 Besam US Inc. May not be reprinted without permission
SHROUD
SENSOR
COVER
ULTRAVIEW
US02-0640-02
-
US15-0640-14
designated P2.
QUICK DISCONNECT HARNESS(2 per system)
MOUNTING SCREWS
(Not available as a spare part)
DIP SWITCH
STOP/IMPULSE(BREAKOUT INPUT)
P2
P1
STD/AUX SWITCH
KNOWING ACT INPUT (AUX)
US02-0640-05
SHORT (black)
EXTENSION HARNESS
US02-0640-04
EXTENSION HARNESS
07-30-09
LONG (gray)
US02-0640-03
V4
4
Advertisement
Table of Contents
