Converting The Hub [Inserted Adapters] - DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual

3.3

Converting the Hub [Inserted Adapters]

Figure 3-1: Overview: front wheel with inserted adapters
1 adapter left
2 ball bearing
Preparatory Steps
not required
Required Material
multipurpose grease
NOTICE
Risk of damaging the adapters!
To avoid damages, only use grind clamping jaws, aluminium clamping jaws or special tools to clamp
the adapters.
Removing the Adapters
1. Clamp one of the adapters (Abb.3-1/1, 5) into a
vice.
2. Pull off the wheel, respectively the hub.
3. Clamp the second adapter into the vice.
4. Pull off the wheel, respectively the hub.
3 axle
4 hub shell
Specification
®
Single Shot 2 Technical Manual
5 adapter right
Link
Amount
as required
12