Removing A Single Spoke On The Front Wheel [Non-Slotted Hub] - DT SWISS SPLINE ROAD 2014 RC 28 Technical Manual

5.6.3 Removing a Single Spoke on the Front Wheel [Non-Slotted Hub]

Preparatory Steps
Dismount the wheel.
Dismount the tire and if necessary the tube and the rim tape.
Clean the wheel and check for damages.
Loosen the spoke.
1. Remove the end cap.
a) Put the axle holder (see
a vise.
b) Clamp the end cap on the side of the spoke
which needs to be replaced into the axle hol-
der.
c) Pull the wheel upwards using both hands.
d) Remove the end cap from the vise.
2. Slide the spoke with the nipple out of the rim.
3. Slide the spoke out of the hub.
4. Slide a new spoke through the hub.
chap. 5.2, page 46) into
®
SPLINE Technical Manual
Link
chap. 5.6.1, page 59
63