5 Converting the Control Elements
DT Swiss forks are available with manual or remote control elements. The following chapters describe
the conversion between these versions and the installation of the remote levers.
•
Converting from remote to manual operation:
•
Converting from manual to remote operation:
•
Installing the Two In One remote lever:
•
Installing the lightweight remote lever:
5.1
Converting from Remote to Manual Operation
Preparatory Steps
Clean the fork.
Check all functions of the fork.
Required Material
thread lock
Removing the Remote Control Elements
1. Hold the rebound wheel and unscrew the fixing
screw using a T8 Torx-key.
Holding the rebound wheel prevents that the re-
bound wheels gets stuck in the stop position.
2. Take off the rebound wheel and the fixing screw.
3. Unscrew the fixing nut of the remote wheel using
an 8 mm hex-key.
4. Remove the nut.
chap. 5.3.2, page 35
chap. 5.3.1, page 34
Specification
Loctite 241 or Loctite 243
O.L / Single Shot 2 Forks - Technical Manual
chap. 5.1, page 26
chap. 5.2, page 30
Link
Amount
as required
26