Hino Motors J08E-VC Workshop Manual page 73

EN02–24
Oil seal
Guide bolt
Press
ENGINE MECHANICAL (J08E)
2.
Guide
(1)
(2)
SHTS011060200069
NOTICE
Pay attention to the orientation of the crankshaft oil seal (The felt side
should face the outside of the cylinder block).
SHTS011060200070
(3)
(4)
SHTS011060200071
(5)
(6)
Center bolt
SHTS011060200072
INSTALL THE CRANKSHAFT FRONT OIL SEAL.
SST: Oil seal press (S0940-71030)
Clean the edges and surface of the crankshaft and the special tools.
Insert a new crankshaft oil seal into the guide of the oil seal press.
Apply a little engine oil to the seal portion of the crankshaft oil seal.
Attach the oil seal press guide with the new crankshaft oil seal onto
the crankshaft using the attached guide bolt.
Insert the oil seal press by adjusting the oil seal press hole to the
guide bolt.
Press the crankshaft oil seal inside by attaching the accompanying
center bolt onto the oil seal press and tightening it until it stops.