Hino Motors J08E-VC Workshop Manual page 209

EN07–8
Bearing holder case
Do not remove
pipe A.
Incorrect
Do not grip pipes and joint bolts when holding the supply pump
FUEL SYSTEM (J08E)
(3)
(4)
Seated
Special tool
! CAUTION
Not seated
•
•
SAPH011060700013
•
•
9.
! CAUTION
•
•
•
•
Do not remove
pipe B.
SAPH011060700014
Remove the timing check window plug from the bearing holder case
of the supply pump.
Mount the special tool specified below to the timing check window of
the bearing holder case to see that the bearing surface of the special
tool is seated on the supply pump.
SST: Guide bolt (SZ105-08067)
If the special tool is not seated, it is in contact with a part other
than the detent of the coupling flange. Do not forcibly tighten the
special tool.
If the special tool is not seated, the No.1 cylinder is not set at the
compression stroke top dead center. In this case, remove the
special tool, turn the crankshaft, and install the special tool
again to see if it is seated.
Before turning the crankshaft, do not fail to pull out the special
tool.
Do not perform cranking with the special tool inserted.
REMOVING THE SUPPLY PUMP
While working, be careful not to make dirt and water enter parts.
Do not remove pipe A and pipe B.
Be careful not to apply excessive load on pipe A and pipe B.
(Pipe twist will cause fuel leakage.)
Do not hold pipe A or pipe B when carrying the pump.
Incorrect Correct
Hold in your arms
SAPH011060700075