Hino Motors J08E-VC Workshop Manual page 103

EN02–54 ENGINE MECHANICAL (J08E)
13. INSTALL THE OIL PAN.
(1)
NOTICE
Refer to "PARTS AND POSITIONS FOR LIQUID GASKET".
(2)
(3)
(4)
(5)
NOTICE
Make sure that the washer is not on the flange.
SHTS011060200163
14. INSTALL THE BLOCK HEATER.
(1)
NOTICE
If O-ring is not applied, it could damage and allow water to leak.
SHTS011060200164
(2)
NOTICE
•
•
SHTS011060200165
Make sure that there is no deformation, impact marks or foreign parti-
cles on the cylinder block, oil pan or flange surface. Apply liquid gas-
ket to the front and back ends of the cylinder block lower surface.
Install the gasket so that the protrusion is at the flywheel housing side
and the intake side. (the print seal surface is at the cylinder block side)
Place a guide pin of 70 mm or more in the cylinder block and assem-
ble the oil pan against the guide.
Tighten oil pan fitting bolts in the order 1 - 2 - 3 - 4 with an impact
wrench.
Tightening Torque:
19.7-24.5 Nm {200-250 kgfcm, 15-18 lbfft}
Finish tightening the bolts with a torque wrench to the specified
torque. Tighten the bolts according to the arrow in the figure.
Apply silicone spray to O-ring. (LPS Laboratories: Parts No.01516 or
equivalent.)
When installing the block heater, match the arrow mark on the heater
to the mark on the cylinder block protrusion.
Do not damage the adapter installation hole, otherwise water will
leak.
If the marks do not match, the heater coil will touch the cylinder
block.