Hino Motors J08E-VC Workshop Manual page 324

AIR COMPRESSOR (J08E: 340 cm3)
IMPORTANT POINTS - ASSEMBLY
1.
(1)
SAPH011061300018
2.
(1)
(2)
(3)
SAPH011061300019
3.
NOTICE
•
•
(1)
SAPH011061300020
(2)
SAPH011061300021
INSTALL THE BALL BEARING.
Install the ball bearing onto the both ends of the crankshaft.
INSTALL THE CRANKSHAFT.
Using the press, install the crankshaft to the bearing holder.
Install the crankshaft and bearing holder into the crankcase.
Tighten the bearing holder fitting screw.
INSTALL THE CONNECTING ROD AND MEASURE THE END
PLAY.
Be sure to align the aligning mark.
Apply engine oil to the connecting rod and cap.
Apply engine oil to the thread before installing the connecting rod bolt.
Measure the connecting rod end play.
Assembly standard: 0.2-0.4 mm {0.008-0.015 in.}
Limit: 0.5 mm {0.02 in.}
EN13–11