Overhaul - Hino Motors J08E-VC Workshop Manual

EN03–6 AIR INTAKE SYSTEM (J08E)

OVERHAUL

IMPORTANT POINTS - DISMOUNTING
1.
(1)
(2)
! CAUTION
•
•
SHTS011060300005
IMPORTANT POINTS - MOUNTING
1.
(1)
NOTICE
Ensure the cover over the thumb screw is properly affixed.
IMPORTANT POINTS - INSPECTION
1.
(1)
SHTS011060300006
(2)
(3)
(4)
! CAUTION
If an abnormality is found during the above inspection, replace the
element with a new one. If dust is taken into the engine, the engine
will wear and its performance will deteriorate.
SHTS011060300007
REMOVE THE AIR CLEANER ELEMENT.
Remove the thumb screw as shown in the figure and remove the
cover.
Hold the outer projection end of the element and turn slightly, then
detach the element.
Never clean the element filter.
When the element filter is subjected to blowing with compressed
air, is washed, hit, or dropped, the filter function will be impaired
and engine damage can be caused.
INSTALL THE AIR CLEANER ELEMENT.
Install in the reverse order of removing.
INSPECTING
If on inspection the dust indicator is red replace it.
If the cover, case or unloader valve is damaged, replace the part.
Check the element to see if it is flattened or deformed, or whether the
filter paper of the element is torn.
Check to see if the sealing of the gasket is complete.
EN0110603H100002