Liquid Gasket And Application Points - Hino Motors J08E-VC Workshop Manual

EN01–22 ENGINE INTRODUCTION (J08E)
LIQUID
POINTS
•
1.
(1)
(2)
(3)
(4)
(5)
2.
(1)
SHTS011060100031
3.
(1)
(2)
SHTS011060100032
GASKET
Liquid gasket is used at the following positions for the J08E series
engine.
Liquid gasket specification:
S0413-21217: Black
Liquid gasket specification:
S0413-21207: Silver
Liquid gasket specification:
S0413-21211: White
LIQUID GASKET APPLICATION AND PART ASSEMBLY PROCE-
DURE.
Remove old liquid gasket from each part and matching parts and wipe
off oil, moisture or dirt with a rag.
Overlap the liquid gasket at the start and end of application.
Be careful of misalignment when assembling parts with liquid gasket.
If they are misaligned, reapply the liquid gasket.
Assemble parts within 20 minutes of application.
If more than 20 minutes have passed, remove and reapply the liquid
gasket.
Wait for at least 15 minutes or more after assembly of parts before
starting the engine.
REMOVE PARTS.
When removing parts, do not use a tool for removal at one location
only. Use the tool at various locations such as a flange step or gap for
removal. When removing the gasket, be careful that gasket residue
does not enter the engine.
OTHERS.
For tube-type liquid gasket, use the winding tool that comes with the
liquid gasket.
For cartridge-type gasket, use an application gun.
AND APPLICATION
EN0110601H200001