Hino Motors J08E-VC Workshop Manual page 46

No. Part name
1 Oil seal retainer
2 Coolant pump
3 Oil cooler
4 Thermostat case
ENGINE INTRODUCTION (J08E)
(3)
1: Approximately 2 mm wide when cut at the first step
2: Approximately 5 mm wide when cut at the second step
SHTS011060100033
4.
(1)
Application position and pattern
Matching flange face with the block
Matching flange face with the block
Matching flange face with the block
Matching flange face with the cylinder head
For tube-type liquid gasket, required width of application can be
obtained by cutting the nozzle to suit.
PARTS AND POSITIONS FOR LIQUID GASKET.
Apply liquid gasket to positions and types of gasket according to the
table shown below.
Follow the application pattern at each position shown in the figures.
Unit: mm {in.}
Gasket
Application
to be
width
used
1.5-2.5
{0.0591- Black
0.0984}
1.5-2.5
{0.0591- Black
0.0984}
1.5-2.5
{0.0591- Silver
0.0984}
1.5-2.5
{0.0591- Silver
0.0984}
EN01–23
Remarks