Hino Motors J08E-VC Workshop Manual page 229

EN07–28
Injector
harness
bracket
Injector
harness
Injector
harness
Union bolts
Leakage pipe
A : Injector (M8 1.0)
B : Camshaft housing (M8 1.25)
Leakage pipe
FUEL SYSTEM (J08E)
3.
(1)
Connector
(2)
! CAUTION
Nut
Before connecting the connectors, make sure that the terminals are
free of a spark mark.
SAPH011060700062
NOTICE
Connector
It is easy to connect the connectors by first connecting the one to the
camshaft housing.
Camshaft
housing
SAPH011060700063
4.
Union bolts
(1)
(2)
! CAUTION
•
•
SAPH011060700064
•
SAPH011060700065
MOUNTING THE INJECTOR HARNESS
Mount the injector harness together with the injector bracket with the
bolts (7 pcs.) that secured them.
Connect each connector of the injector harness.
MOUNTING THE LEAKAGE PIPE
Remove dirt or foreign matters from the gasket mounting surface.
Replace the gasket with a new one, and mount the leakage pipe on
the injector and the camshaft housing with the union bolts (7 pcs.) that
fastened them.
Tightening Torque:
12.3 Nm {126 kgfcm, 9 lbfft}
Do not reuse the old gasket.
The leakage pipe can be twisted easily. Use care in handling.
Note that the thread pitch is different between the union bolts (6
pcs.) for the injector and the union bolt for the camshaft housing.