Hino Motors J08E-VC Workshop Manual page 61

EN02–12
20 12 4 5
16 8 1
24
23 15 7 2
19 11 3 6
20 12 4 5
16 8 1
24
23 15 7 2
19 11 3 6
ENGINE MECHANICAL (J08E)
4.
(1)
SHTS011060200031
(2)
(3)
(4)
27
28
13 21
9 17 25
29
10 18 26
14 22
SHTS011060200032
(5)
(6)
(7)
(8)
NOTICE
When adding torque, never untighten the bolts, even if they have been
overtightened.
SHTS011060200033
(9)
27
28
13 21
9 17 25
29
10 18 26
14 22
SHTS011060200034
5.
TIGHTEN THE CYLINDER HEAD BOLT.
Measure the length of the M12 head bolts, if the length is A or more,
replace with new bolts.
Dimension A
Apply clean engine oil to the bolt surface and bolt threads of the M10
and M12 bolts.
Clean the bolt seats completely on the cylinder head upper surface.
Tighten No. 1 - No. 26 (M12 bolts) in the order shown in the figure to
the specified torque.
Tightening Torque:
59 Nm {600 kgfcm, 43.4 lbfft}
Mark the M12 bolts with paint to indicate the same directions as
shown in the figure.
Turn No. 1 - No. 26 (M12 bolts) 90 (1/4 turn) in the same order as in
(4).
Retighten them 90 (1/4 turn) as step (6).
Make sure that all paint marks face the same direction.
Tighten No. 27 - No. 29 (M10 bolts) in the order shown in the figure to
the specified torque below.
Tightening Torque:
59 Nm {600 kgfcm, 43.4 lbfft}
INSTALL THE CAMSHAFT HOUSING.
125.5 mm {4.941 in.}