Hino Motors J08E-VC Workshop Manual page 283

Harness
coupler
Clip
Sensor
Clip
Harness
coupler
Clip
Sensor
Clip
Item
DEF filter element (& equalizing element)
EMISSION CONTROL (J08E)
9.
(1)
NOTICE
After removing the sensor, check that there is no entry of foreign mat-
ters inside the muffler.
SHTS011061000061
(2)
NOTICE
SHTS011061000062
When reassembling, apply anti-seizure lubricant to the temperature
sensor.
INSPECTION AND REPAIR
Inspect the SCR-related components in accordance with the table
below and perform a repair or replacement if necessary.
Replacement
NOx SENSOR 2
IMPORTANT POINT - DISMOUNTING
a. Remove the clips.
b. Disconnect the harness coupler.
c. Remove the NOx sensor controller.
d. Remove the sensor.
IMPORTANT POINT - MOUNTING
a. Mount the sensor.
Tightening Torque:
40-60 Nm {407-611 kgfcm, 29-44 lbfft} (Sensor)
Tightening Torque:
3.9-7.1 Nm {40-72 kgfcm, 2.9-5.2 lbfft} (Controller)
b. Mount the NOx sensor controller.
c. Connect the harness coupler.
d. Mount the clips.
Content
Replacement
Action Travel distance
60,000 mile
EN10–27
EN0110610H300001