Hino Motors J08E-VC Workshop Manual page 109

EN02–60
Inspection item
Center journal width
Thrust bearing thick-
ness
Crankshaft end play
Crankshaft deflection
Clogging of crankshaft
oil hole
Crack and wear of crank-
shaft
*Dye penetrant check
(Color check)
Cylinder block upper
surface flatness
ENGINE MECHANICAL (J08E)
Standard
36 {1.417}
2.5 {0.0984}
0.5 {0.0197}
0.050-0.270 {0.0020-
0.0106}
1.270 {0.0499}
— 0.15 {0.0059}
—
—
Longitudinal direc-
tion: 0.06 {0.0024}
Right angle direc- 0.20 {0.0078}
tion: 0.03 {0.0012}
or less
Limit Remedy
37 {1.456} Replace crankshaft.
— —
More than
Replace over size
thrust bearing.
(Repair)
Replace crankshaft.
(Service)
Regrind under size.
— Clean.
— Replace.
Replace.
NOTICE: Do not grind
for repair.
Inspection procedure
Measure
Measure
Visual check
Visual check
Measure