Hino Motors J08E-VC Workshop Manual page 62

Idle gear
thrust plate
Cylinder head
90
ENGINE MECHANICAL (J08E)
6.
NOTICE
•
•
Lubrication
hole
SHTS011060200035
7.
(1)
A
SHTS011060200036
(2)
(3)
SHTS011060200037
(4)
NOTICE
When adding torque, never untighten the bolt, even if it has been
Marking
overtightened.
SHTS011060200038
INSTALL THE CAM IDLE GEAR.
Install the cam idle gear shaft through the thrust plate as shown
in the figure so that the lubrication hole is downward.
Apply clean engine oil to the bolt seat and bolt threads.
ASSEMBLE THE CAMSHAFT GEAR.
Measure the length of the camshaft gear bolts, if the length is A or
more, replace with new bolts.
Dimension A
Make sure that there is neither damage to the camshaft gear or cam-
shaft nor dirt on them.
Apply clean engine oil to the bolt surface and bolt threads and tighten
them to the specified torque below.
Tightening Torque:
59 Nm {600 kgfcm, 43.4 lbfft}
Turn bolts an additional 90 (1/4 turn).
EN02–13
30 mm {1.18 in.}