Hino Motors J08E-VC Workshop Manual page 248

EN08–12
Turbocharger
insulator(upper)
Turbocharger
insulator(lower)
TURBOCHARGER (J08E)
REPLACEMENT
REMOVING THE TURBOCHARGER ASSEMBLY
NOTICE
•
•
•
1.
(1)
2.
(1)
Electric
actuator
Connector
SAPH01Z080800001
3.
(1)
4.
(1)
SAPH01Z080800002
(2)
SAPH01Z080800003
Use care not to touch the link rod and adjusting screw.
The link rod the electric actuator has been adjusted. Do not
remove it. Removal of the link rod may cause misalignment,
resulting in turbocharger functional decline.
The adjusting screw for opening/closing operation of the turbo-
charger assembly has been adjusted. Do not loosen it.
DARAINING THE COOLANT
Drain the coolant.
Reference:COOLING SYSTEM(J08E)
DISCONNECTING THE HARNESS
Disconnect the electric actuator connector.
REMOVING THE INTAKE PIPE(EXHAUST SIDE)
Remove the intake pipe(exhaust side).
Reference:AIR INTAKE SYSTEM(J08E)
REMOVING THE TURBOCHARGER INSULATOR
Unfasten the bolts to remove a turbocharger insulator (upper) from a
turbocharger assembly.
Unfasten the bolts to remove the turbocharger insulator (lower) from
the turbocharger assembly.