Hino Motors J08E-VC Workshop Manual page 56

ENGINE MECHANICAL (J08E)
(8)
NOTICE
•
•
SHTS011060200015
2.
(1)
SHTS011060200016
(2)
NOTICE
Attaching tags to the valves (giving corresponding cylinder Nos.) will
eliminate time required for lapping the valve seats on reassembly.
SHTS011060200017
3.
(1)
NOTICE
Be careful not to damage the cylinder head lower surface when
removing carbon deposits or foreign particles.
SHTS011060200018
Lift and remove the cylinder head using the special tool and hoist.
SST:
Eye bolt (S0943-31070)
Wire (S0949-11010)
Do not damage the cylinder head lower surface or cylinder block
upper surface during removal of the cylinder head.
If it is difficult to lift off the cylinder head, pry with a chisel
between the cylinder head and cylinder block.
DISASSEMBLE THE VALVE SYSTEM.
Remove the valve spring retainer using the special tool.
SST: Valve spring press (S0947-01170)
Remove the intake and exhaust valve.
CLEAN THE CYLINDER HEAD.
Clean the cylinder head and remove carbon deposits or foreign parti-
cles.
EN02–7