Inspection And Repair - Hino Motors J08E-VC Workshop Manual

EN13–14
Inspection item
Cracks or defects of the con-
necting rod
Outside diameter of piston pin
Clearance between the piston
pin and connecting rod
Inside diameter of the connect-
ing rod
(Tighten the bearing cap to the
specified torque.)
Outside diameter of the crank
pin
Oil clearance between the con-
necting rod and the crank pin
Connecting rod end play
AIR COMPRESSOR (J08E: 340 cm3)

INSPECTION AND REPAIR

Standard Limit
—
18 {0.709}
0.016-0.044
0.07 {0.0028}
{0.0007-0.0017}
34 {1.339}
34 {1.339}
0.025-0.075
0.1 {0.0039}
{0.0010-0.0029}
0.2-0.4
0.5 {0.0197}
{0.0079-0.0157}
Remedy
— Replace.
—
Replace.
—
—
Replace.
Replace con-
necting rod or
crankshaft.
EN0110613H300001
Unit: mm {in.}
Inspection procedure
Visual check
Measure
Measure
Measure