Parameter Range And Definition; Parameters Contents And Range - Smartgen HGM1790N User Manual

7.

PARAMETER RANGE AND DEFINITION

7.1 PARAMETERS CONTENTS AND RANGE

No. Parameter
P00 Start Delay
P01 Stop Delay
P02 Start Attempts
P03 Preheat Time
P04 Cranking Time
P05 Crank Rest Time (3-60)s
P06 Safety On Delay
P07 Start Idle Time
Warming Up
P08
Time
P09 Cooling Time
P10 Stop Idle Time
ETS Solenoid
P11
Hold
Fail to Stop
P12
Delay
P13 Flywheel Teeth
HGM1790N Genset Controller User Manual
Table 7 Parameter Setting Contents and Range
Default
Range
Value
(0-3600)s
(0-3600)s
(1-10) times
(0-300)s
(3-60)s
(1-60)s
(0-3600)s
(0-3600)s
(3-3600)s
(0-3600)s
(0-120)s
(0-120)s
(1-300)
Time from remote start signal is active
1
to start genset.
Time from remote start signal is
1
deactivated to stop genset.
The maximum
attempts. If none of them is successful,
3
the controller will initiate fail to start
alarm.
Time of pre-powering heat plug before
0
starter is powered up.
The time of powering up the starter for
8
every crank attempt
The waiting time before second power
10
up when engine start fail.
Alarms for low oil pressure, high
10 temperature,
frequency and under voltage are inactive.
Idle running time of genset when
0
starting.
Warming time between genset switch on
10
and normal running.
Radiating time before genset stop, after
10
it unloads.
0 Idle running time when genset stop.
The time
20
electromagnet during stop procedure.
Time between ending of genset idle
delay and stopped when "ETS output
time" is set as 0;
0
Time between ending of ETS hold delay
and stopped when "ETS output time" is
not 0.
Tooth number of the engine is for
judging of crank disconnect conditions
118
and inspecting of engine speed. See the
installation instructions.
Description
number of crank
under speed, under
of powering up
Page 16 of 31
the