Controller Function Setting; Parameter Setting - Smartgen HGM1790N User Manual

8.

CONTROLLER FUNCTION SETTING

8.1. PARAMETER SETTING

Hold and press
follows,
1) Press button to increase the value of the blinking digit and
when the first digit is set, press
2) Repeat the same procedure to set the digits from 2
3) If the password is right, enter into the parameter configuration interface (as shown below) which
including the serial number of the set items and their parameters; press
to scroll up;
4) Press to set the current item, and when the first digit starts blinking, use the same way that
is used for password to enter the set value.
Attention:
a) Please change the controller parameters when generator is in standby mode only (e. g. Crank
disconnect conditions selection, configurable input, configurable output, various delay),
otherwise, shutdown and other abnormal conditions may happen.
b) Serial number of parameters please reference Table 7
c) The value of each parameter can be set only within a certain range; otherwise, it can't be
changed.
d) Over voltage set value must be higher than under voltage set value, otherwise over voltage
and under voltage condition may occur simultaneously.
e) Over speed set value must be higher than under speed set value, otherwise over speed and
under speed condition may occur simultaneously.
f) Please set the generator frequency value as low as possible when cranking, in order to make
the starter be separated quickly as soon as crank disconnect.
g) Before selecting fuel level sensor type, it is necessary to set a configurable input port type as
8 first.
HGM1790N Genset Controller User Manual
for 2s to enter into password interface, and the fist digit is blinking as
Fig.3 Password Interface
to move the cursor;
Fig.4 Parameter Configuration Interface
nd th
to 4 ;
to decrease the value;
to scroll down and
Page 24 of 31