Smartgen HGM1790N User Manual page 19

No. Parameter
P31 Action
P32 Aux. Output 3
P33 Digital Input
Digital Input
P34
Delay
P35 Power On Mode
P36 Password Set
Crank
P37 Disconnect
Condition
Disconnect
P38
Engine Speed
Disconnect
P39
Generator Freq
Disconnect Oil
P40
Pressure
P41 AC System
P42 Temp. Sensor
P43 OP Sensor
Fuel Level
P44
Sensor
Disconnect Oil
P45
Pressure Delay
HGM1790N Genset Controller User Manual
Default
Range
Value
(0-2)
(0-9)
(0-8)
(0-20.0)s 2.0
(0-2)
(0-9999) 0318
(0-6)
(0-3000) RPM 360
(10.0-30.0) Hz 14.0
(0-400) kPa 200
(0-3)
(0-10) 06
(0-10) 06
(0-7)
(0-20.0)s 0.0s
current alarm will be initiated.
0: Warn 1: Shutdown 2: Cooling and
0
Shutdown
1 Default: Common Alarm
Default: Auxiliary shutdown; if the set
4 value is 8, fuel level sensor type can be
selected.
Active delay time for digital input ports
0 0: Stop 1: Manual 2: Auto
See table 11.
Starter disconnection condition. There
are 3 conditions of disconnecting starter
1 with engine (speed, generator frequency
and oil pressure). Aiming at to separate
the start motor and engine as soon as
possible.
When speed is higher than the set value,
starter will be disconnected.
When generator frequency higher than
the set value,
disconnected.
When generator oil pressure higher than
the set value,
disconnected and oil engine crank
successfully.
0: 3P4W
2: 1P2W
2
It is used for calculating generator
voltage and active power.
SGD (120ºC resistor type)
SGD (10Bar resistor type)
Not used. (If fuel level sensor is used,
0 then the digital input port must be set as
"8 Multiplex Level Sensor".
When crank
including oil pressure, and engine oil
pressure and delay value are higher than
Description
starter will
starter will
1: 2P3W
3: 3P3W
disconnect condition
Page 19 of 31
be
be