Sensor Selection - Smartgen HGM1790N User Manual

7.4

SENSOR SELECTION

No. Items
Temperature
1
Sensor
Oil Pressure
2
Sensor
Fuel Level
3
Sensor
HGM1790N Genset Controller User Manual
Table 10 Sensor Selection
Content
0 Not used
1 Low digital input is active
2 High digital input is active
3 User defined resistor type
4 VDO
5 SGH (Huanghe sensor)
6 SGD (Dongkang sensor)
7 CURTIS
8 DATCON
9 VOLVO-EC
10 SGX 120 DEGREE
0 Not used
1 Low digital input is active
2 High digital input is active
3 User defined resistor type
4 VDO 10Bar
5 SGH (Huanghe sensor)
6 SGD (Dongkang sensor)
7 CURTIS
8 DATCON 10Bar
9 VOLVO-EC
10 SGX 10Bar
0 Not used
1 Low digital input is active
2 High digital input is active
3 User defined resistor type
4 SGH (Huanghe sensor)
5 SGD (Dongkang sensor)
6 Reserved 1
7 Reserved 2
Remark
Digital input is digital signal; low or high
electrical level can be selected to be
active, connecting to earth point will
mean that low electrical level is
selected, hang in air means high
electrical level is selected; cannot be
connected to power supply positive.
The range of user-defined resistor type
sensor is 0-6000Ω, by default SGD
sensor is selected.
Digital input is digital signal; low or high
electrical level can be selected to be
active, connecting to earth point will
mean that low electrical level is
selected, hang in air means high
electrical level is selected; cannot be
connected to power supply positive.
The range of user-defined resistor type
sensor is 0-6000Ω, by default SGD
sensor is selected.
Digital input is digital signal l; low or
high electrical level can be selected to
be active, connecting to earth point will
mean that low electrical level is
selected, hang in air means high
electrical level is selected; cannot be
connected to power supply positive.
The range of user-defined resistor type
sensor is 0-6000Ω, by default "Not
used" is selected
Before selecting fuel level sensor type,
digital input type must be set as 8.
Page 22 of 31