Function Button - AJAX KeyPad Plus User Manual

Before entering a password or using Tag/Pass, you should activate ("wake up") the KeyPad
Plus by sliding your hand over the touch panel from top to bottom. When it is activated, the
button backlight is enabled, and the keypad beeps.
The KeyPad Plus is equipped with LED indicators that show the current security mode and
keypad malfunctions (if any). The security status is displayed only when the keypad is
active (the device backlight is on).
You can use the KeyPad Plus without ambient lighting as the keypad has a backlight. The
pressing of the buttons is accompanied by a sound signal. The backlight brightness and
keypad volume are adjustable in the settings. If you do not touch the keypad for 4 seconds,
KeyPad Plus reduces the backlight brightness, and 8 seconds later goes into power-saving
mode and turns off the display.
If the batteries are discharged, the backlight turns on at the minimum level regardless of the settings.

Function button

KeyPad Plus has a Function button that operates in 3 modes:
Off — the button is disabled and nothing happens after it is pressed.
Alarm — after the Function button is pressed, the system sends an alarm to the
security company monitoring station and all users.
Mute interconnected re alarm — after the Function button is pressed, the system
mutes the re alarm of the FireProtect/FireProtect Plus detectors. Available only if an
Interconnected FireProtect Alarm
Fire detectors settings)
is enabled (Hub → Settings → Service →