Settings; Startup & Shutdown - Safety Vision RoadRecorder 9000 User Manual

21

Settings

Startup & Shutdown
Select the Settings tab from the top, then click Startup/Shutdown.
The Startup/Shutdown page allows you to configure startup and shutdown conditions of the NVR.
Startup
• Enable Temperature check Startup Delay: If enabled,
firmware will check temperature before starting the NVR.
If the NVR temperature rises to threshold temperature,
NVR will start immediately.
• Minimum Threshold Temperature: Enter the minimum
temperature (in Celsius) the NVR should contain before
starting up. If the temperature is below threshold,
the firmware will wait for a set duration to allow the
temperature to rise.
• Duration: Enter the amount of time,
minutes, the NVR will wait for the temperature to rise.
If temperature is still below threshold the NVR will still
start up.
Shutdown
• Continue recording after Ignition Off: If enabled, the
NVR will continue to record for the specified duration after
the vehicle's ignition has been turned off.
• Record Duration: Enter the amount of time,
to 300 minutes, the NVR will continue to record after the
vehicle's ignition has been turned off.
• Enable Offload to SafetyNet: Select this option to allow
the NVR to continue to offload data to a SafetyNet server
ROADRECORDER® 9000 USER GUIDE
between 1 to 1440
between 0
for the specified duration after the vehicle's ignition has
been turned off.
• Max Transfer Duration: Enter the amount of time,
between 0 to 360 minutes (decimal values are not
the NVR will continue to offload data to a SafetyNet server
after the vehicle's ignition has been turned off.
• SafetyNet Announce
Select when the NVR is available to ping the server:
(NOTE: SafetyNet Server Announce must be enabled under
the Network Settings page in order to access the settings in
this field).
◦ None: If this option is selected, NVR will never ping
the server.
◦ Always
(recommended
selected, NVR will ping the server after recording
starts at intervals of 60 seconds.
◦ Geo fence: If this option is selected, NVR will ping the
server as per geo-fence configuration.
allowed),
setting): If this option is