Specifications; Nameplate; Storage; Measures During Storage - Danfoss VLT OneGearDrive Operating Manual

VLT® OneGearDrive®
Operating Guide

9 Specifications

9.1 Nameplate

The nameplate on the VLT® OneGearDrive® is corrosion-proof. It is made of a special plastic, approved for hazardous areas by the
Physikalisch-Technische-Bundesanstalt (PTB).
P/N: 123X5678
Type OGDSK231K131401L06RXTB1P3S9010H1B2201XXX
123X5678000101Q140
1
U= 3x380..480VAC
2
max= 2.3kW V210
3
I = 5.5A 105˚C (A)
nom
4
f = 250Hz t = 40˚C
max amb
Inverter Duty Motor
Illustration 14: Example Nameplate
1 Supply voltage
2 Power
3 Nominal motor current
4 Motor frequency
5 Gear ratio

9.2 Storage

If the VLT® OneGearDrive® is to be stored, ensure a dry, dust free, and well-ventilated environment. If the temperature in the storage
space exceeds the normal range of –20 °C (–4 °F) to 40 °C (+104 °F) for an extended period or varies frequently, employ the meas-
ures before start-up specified in
Damage sustained during storage:
• The life of the oils and seals is reduced with longer storage times.
• There is a risk of fracture at low temperatures (under approximately –20 °C (–4 °F).
If the VLT® OneGearDrive® is being stored for an extended time before start-up, increased protection against damage by corrosion
or humidity can be achieved by observing the information in
serve the instructions in this Operating Guide.
The actual load depends strongly on local conditions, therefore the time period stated is only a guiding value. This period does not
include any extension of the warranty.
If disassembly is necessary before start-up, contact Danfoss Service.

9.2.1 Measures during Storage

Turn the VLT® OneGearDrive® 180° every 12 months so that the oil in the gear unit covers the bearings and gear wheels that were
previously positioned on top. Also, turn the output shaft manually to churn the rolling-contact bearing grease and distribute it
evenly.

9.2.2 Measures after Storage

Repair any damage to the exterior paint layer or to the rust protection of the bright hollow shafts.
Check that the VLT® OneGearDrive® contains the correct amount of oil and confirm the correct mounting position (see
ing the Oil).
Danfoss A/S © 2020.12
VLT
OneGearDrive
Made in Italy VAI
S/N: 000101Q140
i= 31.13 BRK 220VDC
M = 380Nm
max
n = 96rpm
max
IP67 KTY 84-130
P3=3.1 L Optileb
24kg
Danfoss A/S
6430 Nordborg, Denmark
6.1 Measures before Commissioning, even after short storage times.
5
6
7
8
9
6 Brake data
7 Output torque
8 Output speed
9 Mounting position and oil data
9.2.1 Measures during Storage
Specifications
and 9.2.2 Measures after Storage. Ob-
8.5.4 Chang-
AQ347551551757en-000101 / 130R0239 | 29