Danfoss VLT OneGearDrive Operating Manual page 42

VLT® OneGearDrive®
Operating Guide
VLT® OneGearDrive® Glossary
A
Ambient temperature
Axial force
C
CE
CSA
Cage clamp
CleanConnect
E
EHEDG
ExtensionBox
F
f
max
G
Gear ratio
H
Hygienic
I
I
MAX
I
N
IP
Installation elevation
M
M20x1.5
M
HST
M
MAX
Mechanical brake
M
n
Motor shaft
Mounting set
42 | Danfoss A/S © 2020.12
The temperature in the immediate vicinity of the system or component.
The force in newton-meters acting on the rotor axis in the axial direction.
European test and certification mark.
Canadian test and certification mark.
Wire retention method without using special tools in the terminal box.
EHEDG certified connection from Danfoss with a stainless steel connector.
European Hygienic Engineering and Design Group.
Optional part for VLT® OneGearDrive® that increases the output torque.
Maximum frequency specified.
The speed ratio of the input pinion and the output shaft of the VLT® One-
GearDrive®.
Variant of the VLT® OneGearDrive® for hygienic critical areas.
Maximum allowed current for the VLT® OneGearDrive®.
Nominal current specified for the VLT® OneGearDrive®.
International protection codes.
Installation elevation above normal sea level, typically associated with a de-
rating factor.
Thread specification in the terminal box.
Maximum allowed high starting torque within 3 s and 10 cycles/h for the
VLT® OneGearDrive®.
Maximum allowed torque in part-load operation for the VLT® OneGear-
Drive®.
Option for the VLT® OneGearDrive®.
Specified nominal torque for the VLT® OneGearDrive®.
Rotating shaft on the A side of the motor, typically without a key groove.
Extra components to fix the torque arm to the conveyor frame and included
in the torque arm set.
Glossary
AQ347551551757en-000101/130R0239